Categories
- Build Features (8)
- Building the Hulls (16)
- Hull Frames (6)
- Sheeting the Hull (7)
- Construction Facilities (13)
- Dinghy (3)
- Internal Fitout (21)
- Joining the Hulls (7)
- Launch (1)
- People (4)
- Injuries (2)
- Preparations (10)
- Site Housekeeping (2)
- Systems (11)
- Electrical (4)
- Motors (3)
- Paint (1)
- Plumbing (1)
- Rigging (2)
- Travels (1)
- Uncategorized (9)
Recent Comments
- Troy bell on Timeline
- Bernie on Quick View Start to Finish
- Daryl Reid on Port Outboard Pod
- +femme 7 Jim on Fishing the Wooli River
- SeeBeeZee on Fishing the Wooli River
-
Recent Posts
Archives
- February 2016
- January 2016
- October 2015
- September 2015
- August 2015
- June 2015
- May 2015
- December 2014
- October 2014
- September 2014
- July 2014
- June 2014
- May 2014
- March 2014
- October 2013
- August 2013
- May 2013
- April 2013
- March 2013
- February 2013
- January 2013
- December 2012
- November 2012
- September 2012
- August 2012
- July 2012
- June 2012
- May 2012
- April 2012
- March 2012
- February 2012
- January 2012
- December 2011
- November 2011
- October 2011
- September 2011
- May 2011
Blogroll
- DIY-Yacht Forum used by many Easy cat builders
- Easy Catamarans, web site of Peter Snell, the designer of the Easy's
- Outback Dreamer Web site from another Chris, also an Easy Sarah builder
Monthly Archives: September 2012
Rudders
With the first hull nearly ready to be turned over, the rudder must be fitted. The design specifies the rudder post to be made using 48mm 316SS pipe, which is embedded into laminated plywood. I again used the NACA foil profile as … Continue reading
Posted in Build Features
Leave a comment